Thursday 20 December 2018

Cura 3.6 Concentric top/bottom shells


This is a 1:100 scale SiG33b, modelled by TigerAce1945 (I think), which I sliced with Cura 3.6. I'd read that its Concentric top/bottom shells were much improved, and so I tried it out on this print, and it certainly is better than it used to be. Most importantly from my point of view is that there's no separation between the top and side shells, which I've been getting a lot with the Cura profile I've been using.

No comments:

Post a Comment