Thursday 19 September 2019

Russian Bully-Boys

I'm printing Soviet T-28 medium tanks at the moment.

The left-most one is a resin and metal model from Battlefront, for comparison; the others are designed by M. Bergman, and printed by me in eSun PLA or PLA+, using a slightly modified FDG miniatures profile for the Ender 3.

The most recent print is the middle-right one, printed in plain old PLA. I dropped the temperature for that one right down to 190° — I've found that eSun PLA filaments seem to be happiest printing at much lower temperatures than those actually recommended by the manufacturer. Printing it this cool has given me much cleaner surfaces, and almost no stringing at all.

I'm intending these for the period of the Winter War, 1939-40ish, when the Soviet Union attempted to steamroller Finland and got their arses resoundingly handed to them until eventually numbers (and lack of support for the Finns) began to tell.

They should really be painted white, and I will do a couple like that, but leaving them in green isn't completely out of the question since the Russians went into Finland ridiculously unprepared. And having them green does make them more flexible in terms of their usefulness on the wargames table.

2 comments:

  1. Very well done! Quite like the green.

    ReplyDelete
    Replies
    1. The one to the left (from Battlefront) is a mix I fudged together myself, while the one on the right (3d print) uses Vallejo's relatively new Russian 4B0 in their ModelAir range as the base colour.

      Delete