T18, SU18, SdKfz3 primed

SdKfz 3 (15mm, WSF) primed
Here are my latest military vehicle prints from Shapeways.

I've cleaned off the extraneous printing crap (though possibly not completely, by the look of the T-18's suspension) and sprayed them with Vallejo surface primer, which makes them a thousand percent easier to photograph, without hiding any surface imperfections.

The SdKfz 3 (to the right) has been printed in WSF, while the T-18 and SU-18 (below) have both been printed in FUD.

[Insert here regular complaint about the high cost of printing in decent resolution resin]
T-18 and SU-18 (15mm, FUD) primed.

No comments:

Post a comment

Note: only a member of this blog may post a comment.

4.5cm PaK (t) auf R-35 (f)

 I whipped this up mostly out of digital bits and pieces I had left over from other Blender projects. It's a German hodge-podge of a...