Printable Scenery Ruin


This is the front half of a two-part ruin from Printable Scenery, printed on my Ender 3. It's scaled for use with 28mm figures.

I had originally intended it as a vehicle for using my new static grass applicator, but that turned out to be such a useless piece of junk that I reverted to my old favourite, foam flock. There is a bit of static grass on there, but it was applied via the old sprinkle-and-blow method, rather than via this new-fangled static electrickery.

This is the back half. It's a bit less architecturally interesting than the front, but it has its moments.

And here they are, both together.

1 comment: