Bea

I've finally got around to painting the figure Annette is using for her current character in my D&D5e campaign. She's a two-sword-wielding leather girl, an ex-sergeant in the forces of the Little Sisters of Carnage — hence the red cloak.

Admittedly, at this very instant in the campaign, she, like pretty much everyone else, is pretty much nekkid and have lost nearly all their gear. However, I'm low on character figures that are mostly nekkid and have lost nearly all their gear, so this will continue doing the job until she eventually either gets more clothes and gear, or dies (permanently).

It's another Reaper Bones plastic figure; don't know the product code it's 77035: Deladrin, Female Assassin by Werner Klocke. For some reason my matte varnish refused to go properly matte on this figure, and I'm not really sure why. It was working last time I used it.

No comments:

Post a Comment

Wall of 3d Printed Fire

I found the STLs for this on Thingiverse, but foolishly neglected to take note of exactly where. Hey-ho. This lot took about seven hours t...